C.A 703
Out of stock
With its compact design and built-in test probes, you can take the C.A 703 with you everywhere you go.
AC and DC voltages: 200 mV to 600 V
Current: 200 µA to 200 mA
Resistance: 200 OHM to 20 MOHM
Continuity test (buzzer) and diode test
Safety: IEC 61010 – 600 V CAT IV / 1000 V CAT III
Compare
Related products
-
Digital Multimeters, Electrical, Universal Testing and Safety
C.A 5231
This compact digital multimeter meets the needs of any self-employed electrician.
It is simple to use and exceptionally easy to read thanks to its 6,000-count backlit display with bargraph.
There are two “Off” positions for greater effectiveness, including one which allows no-contact voltage detection. The screen lights up when near to a live cable.
If it is hooked up to a current clamp, it can measure currents up to 600 A in total safety.
SKU: n/a -
Digital Multimeters, Electrical, Universal Testing and Safety
CA.5011
Description
The C.A 5011 TRMS multimeter gives the RMS value whatever the type of signal (sinusoidal or distorted). This makes it ideal for all types of installations, even those involving “non-linear” loads.
Specifications:
- Automatic recognition of AC/DC
- AC/DC voltage: 400 mV to 600 V (5 ranges)
- Operating frequency: 20 Hz to 10 kHz
- Typical accuracy: 0.5% – Impedance: 10 MΩ
- AC/DC current: 400 µA to 10 A (6 ranges)
- Resistance: 400 Ω to 40M Ω (6 ranges)
- Continuity test: (R < 400 Ω) and diode test
- Frequency: 4 kHz to 400 kHz (3 ranges)
- Reading of dB scale from -20 to 16 dB
- Fuse status LED
- “Voltest” LED if a voltage is present in ohmmeter and continuity modes
- Max and Hold functions
- Can be used as a zero galvanometer
- Backlighting
- Dimensions: 160 x 105 x 56 mm
- Weight: 500g
- Use on any installation rated lower than or equal to CAT III 600 V as per IEC/EN 61010-1 Edition 2
SKU: n/a -
-
Digital Multimeters, Electrical, Universal Testing and Safety
CA.5005
Description
The C.A 5005 is a very competitively-priced analogue multimeter designed to meet all the needs of electricians. It is delivered with a current clamp allowing measurement (with direct readings) of AC currents up to 200 A AC.
Specifications:
- DC voltage: 100 mV to 600 V (8 ranges)
- AC voltage: 10 V to 600 V (5 ranges)
- DC current: 50 µA to 10 A (6 ranges)
- AC current: 3 A to 240 A (5 ranges) with MN89 clamp supplied
- Automatic calibration
- “Voltest” LED if voltage present in ohmmeter mode
- Typical accuracy: 1.5%
- Impedance: 20 kΩ/V
- Resistance: 10 kΩ and 1 MΩ
- Audible continuity test: R < 50 Ω
- dB scale (AC voltages)
- Fuse status LED
- Dimensions: 160 x 105 x 56 mm
- Weight: 500 g
- IP53
- Use on any installation rated lower than or equal to CAT III 600 V as per IEC/EN 61010-1 Edition 2
SKU: n/a
